EnviroOrange can be used to remove wine, grease, blood and virtually everything except dyes from carpet and upholstery. Using a 30-1 dilution (or 10-1 for heavy spotting), spray and soak the stain. Work EnviroOrange into the fibers by agitating the surface with a stiff brush. Rinse by pouring hot water onto the stain and dry with a towel.

EnviroOrange can also be used in a carpet shampooer with incredible results. First vacuum the entire carpet, then remove all heavy stains as described above. Use a 50 - 1 dilution in the holding tank of the shampooer. Shampoo the entire carpet, focussing on high traffic areas. Remove excess moisture from carpet with towels, or allow to air dry. - Gum on carpet: Heat a 10:1 dilution in the microwave for 45-55 seconds (careful, it will be hot!). Pour the heated EnviroOrange onto the gum and watch it dissolve!

Back to Top

Use a 120:1 dilution of EnviroOrange for all your windows, mirrors, and glass. (A stronger silution will streak.) To remove scotch tape from glass, mist the area with a 10:1 dilution, then cover with a paper towel soaked with a 10:1 dilution. Remove after 20 minutes, and use a clean towel to wipe off the tape and adhesive.

Back to Top

GLASS WASHING MACHINES
EnviroOrange is excellent for use in glasswashing equipment in restaurants, bars, lounges, hospitals, hotels, etc. Use a 20:1 mixture of EnviroOrange to replace the cleaning and rinsing chemicals. If you use a sanitizer chemical as a last step, continue to do so. Using EnviroOrange will give you a savings of about $100.00 every time you change the pail. Your sales rep can calculate your exact savings.

MILDEW, CALCIUM AND HARD WATER
Apply a 10:1 solution to the area, and leave it for 10 to 20 minutes. Use a stiff brush or non-abrasive pad to remove the build-up.

OVENS
Pre-heat your oven, and then spray a 10:1 dilution of EnviroOrange onto the areas to be cleaned. After letting it sit for 15 minutes, use a non-abrasive scrub pad to help break up the built up grease. Use a towel to wipe up.

STAINLESS STEEL
Use a 10:1 dilution to clean your stainless steel. For best results work with
the grain. Use a 120:1 dilution to finish, then buff with a clean, dry cloth.

Back to Top

Back to Top

Use a 10:1 dilution for all heavy duty bathroom and shower cleaning. To clean shower tiles, leave EnviroOrange on for 10 to 15 minutes. Use a non-abrasive scouring pad to help take off heavy mildew or soap scum. A clean dry bath towel should be used to buff surfaces dry. A light protective coat is left on tiles to help sheen water off.

Back to Top

Add a capful of EnviroOrange to a large glass of hot water, and let your rings, necklaces, chains, bracelets and waterproof watches soak for 10 to 15 minutes. Stir occasionally. Buff your jewellery dry with a clean, dry towel.

Back to Top

EnviroOrange works great in all pressure washers and steam cleaners. Since it is 100% water soluble, it won’t clog nozzles and machines. Use at a 120:1 dilution. Hot water will always give better results than cold.

Back to Top

EnviroOrange replaces varsol, carb cleaner, WD-40 and other poisonous cleaners which can get into your ground water. For floors put 1 litre into a 20 litre pail of hot water. Stir and splash onto your floor. Use a stiff broom
to work the cleaner into your floor. Rinse with water. To remove carbon or grease off shop walls, spray and soak a wall with a 10:1 dilution. Let it sit for 10 to 15 minutes. Use a broom or brush for heavy build-up. Use a pressure
washer or garden hose to rinse.

Back to Top

To remove paint oxidation and overspray use a 7:1 dilution of EnviroOrange. Spray a section and let it sit for 5 to 10 minutes. Use a clean, dry towel to wipe and buff in a circular motion, restoring the paint to its natural lustre.

Back to Top

Spray with a 30:1 solution to remove silicone. Use a towel to buff in a circular motion. For wax and grease removal, use a 30:1 solution in a bucket to hand wash. To remove all traces of grease, oil and dirt, use a 30:1 dilution. Spray evenly, let it sit for 30 seconds then wipe clean and dry with a clean towel or cloth.

Back to Top

A 10:1dilution will remove algae, other build-up, or faded paint. Spray evenly and let it sit for 10 minutes before wiping with an old bath towel. Use a 10:1 solution to clean tarps, awnings, canvas and boat covers. Spray evenly and work it in with a stiff brush. Use a garden hose or pail to rinse. Boat motors can be degreased and kept clean with a 10:1 dilution. Bilge, engines, decks, rust removal and degreasing can all be done with a 10:1 dilution and a brush. Since EnviroOrange is biodegradable, it can be rinsed into the ocean, without affecting the environment. EnviroOrange can also be diluted with sea water.

Back to Top

Aircraft can be maintained both inside and out with EnviroOrange. Use 10:1 for heavy duty applications such as removal of glycol, carbon, grease etc. The interior of aircraft can be maintained with 10:1, 30:1 and 120:1 dilutions, depending on the application (please refer to the dilution guide).

Back to Top

Recreation Vehicles can be kept in spotless condition with Enviro- Orange. Use a 10:1 dilution to remove the black streaks that run down from windows, and to remove heavy build-up.

Back to Top

EnviroOrange helps farmers and ranchers get their maintenance work done quickly, safely and inexpensively. Dairy farmers use it to keep their stainless steel equipment sparkling clean. Heavy machinery, vehicles and equipment can all be degreased and kept clean by EnviroOrange, without poisoning farmland.

Back to Top

Tree sap or pitch can be removed from saw blades with a 10:1 dilution. Spray down the blade, give it a few minutes to loosen up and then wipe it clean with a non-abrasive scrubbing pad. Some sawmills will soak their blades in a pail or drum solution of 30:1 dilution overnight, for an easy clean-up the next morning.

Use a 10:1 or 30:1 solution to keep equipment free of carbide and carbon filings. Spray the equipment, let it sit for a minute or two and wipe it clean.

Back to Top